Extraction Canopies – Commercial Kitchens Buying Advice
It is very important to consider the Material that extraction canopies are made from. 405 to 430 grade stainless steel is used for most good extraction canopies. This is because less expensive materials such as stainless steel are more likely to stain and discolour. Cleaning will become more difficult and the extraction canopies will weaken quicker than they should.
Extraction canopies should feel solid, especially around the filter banks with drain holes at the bottom of the filter bank. Good extraction canopies should have drain taps on the bottom edge; so that the excess oil that can get trapped in the filters can drain away properly and does not just build up within the bottom of extraction canopies.
When dealing with commercial extraction canopies there are several steps you can take to ensure that you have the one, of many extraction canopies, that is right for your needs. Always measure and plan all equipment you are going to need and look for the easiest route out of the area that you require the extraction canopies for the ducting. Companies specialising in extraction canopies will assist with all your requirements. Contact your local councils and planning, and ensure you do not proceed without their approval as you may be required to remove your work regardless of cost.
When considering the duct from extraction canopies and how to extract out of the structure you will be required to calculate and make a decision on the type of the duct and fan you will need. We can help you with this by paying you a free visit, but if you require information for working in a small area you can get in touch with us and we can give advice on what you will require taking into account the size of the room and amount of work. This will not affect where the ducting can be situated on your extraction canopies but you cant decide the building exit area until you know these sizes.
The over heating of oil and fats in frying equipment can cause fire hazards to occur in the ducting of extraction canopies. The fumes are exhaled at 200 to 230 degrees. So it’s crucial that the extraction canopies system is functioning securely and sufficiently. The duct and fan should be operational and located correctly to avoid oil and fat build up.
Cleaning and maintenance of extraction canopies and extraction systems is vital. Extraction canopies should be cleaned weekly along with the filters. As most filters are aluminium or stainless steel you can easily remove and clean with warm soapy water. The duct work and fans should be cleaned every 6 months by a professional cleaning company that will issue the relevant documents for insurance purposes.
Extraction canopies should be looked over to ensure that the maximum internal noise levels of NR40 to 50 is not being exceeded. The highest level when extraction is taking place, should not amplify the sound by any more than 2 db (A) at the end of the fitting. To attain these levels, the user of the slow running fan low velocity can assist you.
There are various different types of extraction canopies, fan sizes, makes and models. These include: Roof Unit, Helious and Ventaxia. There are also many different types of fans, ranging from Turbos, Short case, Long case, Plate fans and Box fans. Each one of these clearly has their own sole position and its vital to make certain you obtained the right one by getting in contact with the extraction canopies business for support. A highly regarded extraction canopies firm will aid you with such support.
Andrew Sutton has been working, fitting Extraction Canopies since leaving school. He has written many articles and you may find many of them on the internet. He has written several articles which you can find on the internet.
Andrew Cambridge has been working, fitting Extraction Canopies since leaving school. When not writing these articles Andrew Cambridge is fitting extraction canopies into commercial kitchens. He has written many articles that are on the internet.